Uncle-milton Roman Candle Fireball Blaster Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Jouets Uncle-milton Roman Candle Fireball Blaster. Uncle Milton Roman Candle Fireball Blaster User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 1
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
2408-0250-0412-V02
MANUFACTURED BY UNCLE MILTON
INDUSTRIES, INC.
P.O. Box 6281
THOUSAND OAKS, CA 91359 USA
©2012 UMI. All rights reserved. ® and
TM
designate
trademarks of Uncle Milton Industries, Inc.
MADE IN CHINA
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE — DO NOT DISCARD
Questions? Visit
unclemilton.com
On/O Light
Push the Fireballs into
the launch tube.
Extend the ring tube to its
maximum length. Then, quickly pull the
ring tube back to launch Fireball. The faster
you pull back, the farther the Fireballs will y.
1
2
3
Battery door
On/Off
sound
effects
ROMAN CANDLE
FIREBALL BLASTER
TM
To turn on the Fireball light, rmly press the ball on the opposite
side of where the light is. Remember to press again to turn o
when not in use to conserve battery life.
WARNING:
CHOKING HAZARD - Toy contains small balls.
Not for children under 3 years.
To protect the environment adults should
carefully open the reball housing using a tool
to remove the batteries. Dispose of the
batteries in a recycle bin, or contact your local
authority for recycling advice and facilities.
Roman Candle Fireballs have non-replaceable
batteries. Do not dispose of Fireballs in re, batteries
inside this product may explode or leak.
Caution: changes or modications not expressly approved
by the party responsible for compliance could void the
user’s authority to operate the equipment.
Do not aim at eyes or face.
Do not shoot at people or animals.
TO AVOID INJURY: Use only Roman
Candle Fireballs designed for this product.
Do not modify Fireballs or the Launcher.
!
Replacing Batteries
Tool required - Small Phillips
head screwdriver.
1. Using a Phillips head screw-
driver, loosen the screw in the
battery cover and remove the
cover.
2.
Install two fresh AAA/LR03
batteries
as indicated in the
battery compartment.
3. Replace battery cover and
tighten screw.
Parts included:
- 1 Blaster
- 3 Light-up Fireballs
Batteries not included
Requires 2 x 1.5V AAA/LR03 batteries
x2
A A A / L R 0 3
BATTERY SAFETY INFORMATION
Non-rechargeable batteries are not to be recharged.
Rechargeable batteries are to be removed from the toy
before being charged.
Rechargeable batteries are only to be charged under
adult supervision.
Different types of batteries or new and used batteries
are not to be mixed.
Batteries are to be inserted with the correct polarity.
Exhausted batteries are to be removed from the toy.
The supply terminals are not to be short-circuited.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries.
Do not dispose of batteries in re. Battery may explode
or leak.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
5+
2408
Vue de la page 0
1

Résumé du contenu

Page 1 - FIREBALL BLASTER

2408-0250-0412-V02MANUFACTURED BY UNCLE MILTON INDUSTRIES, INC.P.O. Box 6281THOUSAND OAKS, CA 91359 USA©2012 UMI. All rights reserved. ® and TM design

Commentaires sur ces manuels

Pas de commentaire